![]() Select TX Delay (touch-screen), then choose “HF”. This is a one-time adjustment and need not be touched again after setting. TX Delay is adjusted in the software menu and should be set to 25 ![]() ![]() You must change: TX Delay* and CW VOX Delay** (hang-time). W ith its default settings, in CW mode the 7300 begins sending RF to the Ampįaster than the Amp’s slow open-frame T/R relay can switch to TX. Unless you purchased the expensive QSK-5 PIN-Diode option for your Ameritron amplifier, y ou must make two timingĪdjustments to the 7300 before it will work properly with these amps, especially if you work CW or digital modes. INTERFACING THE IC-7300 TO AMERITRON TUBE AMPLIFIERS*:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |